Farda Pathobiology and Genetics Laboratory +98 21 2612 3800 No. 16, Lavasani (Farmanieh), Pasdaran, Tehran

Test preparation guides

Semen analysis

  1. Collect the sample after 3 to 5 days without sex or ejaculation. A sample collected less than two days or more than seven days after the last ejaculation is not suitable for the test.
  2. A fever in the 3 days before the test affects the result.
  3. The sample should be collected at the lab. If it is not, it must reach the lab within half an hour: a sample more than half an hour old cannot be tested.
  4. When you hand in the sample, tell the lab staff the exact time it was collected.
  5. The best sample is collected by masturbation into the special container the lab gives you.
  6. A sample collected in a condom is not suitable for the test.
  7. Wash your hands thoroughly before collecting the sample.
  8. Empty your bladder completely before collecting the sample.
  9. Before collecting, hold the container in your hand for a while to bring it to about body temperature (37 °C).
  10. Make sure all of the semen goes into the container, otherwise the result will not be accurate.
  11. Take care that no part of your body touches the inside of the container. For a semen culture, if it does, ask the sampling unit for a new container.
  12. Don’t let the sample get colder than 30 °C or warmer than 40 °C. Until you hand it in, keep it close to body temperature (37 °C).
  13. Alcohol and smoking: Alcohol and smoking can affect the result, so avoid them for at least 24 hours before the test.
  14. Medicines: Some medicines can affect sperm quality. Tell your doctor about any medicines or supplements you take.
Guides for other tests